Rapid-air DUAL SWIVEL REEL: 100 & 1000 SERIES User Manual

DUAL SWIVEL REELOPERATING INSTRUCTIONSRAPID-AIR CORPORATION4601 KISHWAUKEE ST. • ROCKFORD, IL 61109-2925Phone: (815) 397-2578 • Fax: (815) 398-3887 •

PLUG IN HORSEPOWER RESISTOR A Plug-in horsepower resistor must be installed to match the RAMM to the motor horsepower and voltage. See table 2 for

INTRODUCTION The RAMM full wave solid state DC motor speed control represents the latest state of the art design achievable through modern technology.

Fig. 1 Basic RAMM Connection Diagram CAUTION: Do not bundle potentiometer connections (P1, P2, P3) and inhibit connections (I1, I2)

1. AC line fuse is chosen according to the maximum rating of the control: 12 AMP fuse for all motors up to 3/4 HP-90V and 1 1/2 HP-180VDC.

The following procedure, presented in order of adjustment sequence, should be used when readjusting all trimpot functions. Fig. 2 ACCEL/DECEL TRIMPO

3. Lock shaft of motor (be sure CL pot is in full CCW position). Apply power and rotate CL pot CW slowly until DC ammeter reads 1.5 times motor rat-in

LIMITED WARRANTY - RAMM 125, 225, 225D For a period of one (1) year from date of original purchase Rapid-Air Corporation will repair or replace witho

OPERATING INSTRUCTIONS DUAL SWIVEL REELS Installation 1. The machine that you have just received is fully assembled and ready to be put into position

MECHANICAL OPERATING PROCEDURE To Load or Unload a Coil Ring a) If your reel has fixed center shaft go to step 1. b) If your reel has an adjustable

DANCER ARM LOOP HEIGHT ADJUSTMENT Eight different loop sensing arm operating positions are selected manually during set-up. By increment

START UP PROCEDURE Prior to applying power to the machine the operator should review all the controls on the machine. A brief summary of the control

TAUT STOCK The Taut Stock feature monitors the loop between the reel and the external equipment. If the loop gets small enough to possibly cause dama

TROUBLE SHOOTING GUIDE MAIN SWITCH ON BUT NOT LIT 1. CB Tripped a. Reset CB 2. Unit not plugged into main power a. Plug into

4. Percent speed pot set too low. a. Adjust percent speed pot to 100% 5. Fuses blown. a. Check fuses on D.C. drive board. 6. N

RAMM SOLID STATE DC MOTOR SPEED CONTROL SAFETY WARNING - PLEASE READ CAREFULLY This product should be installed and serviced by a qualified technicia