Rapid-air PALLET MASTER (PMD) HIGH SPEED: 35, 50 & 100 S User Manual

RAPID-AIR CORPORATION4601 KISHWAUKEE ST. • ROCKFORD, IL 61109-2925Phone: (815) 397-2578 • Fax: (815) 398-3887 • Web Site: www.rapidair.comMODELS35, 5

Safety Warning - Please Read Carefully Improper installation practices can cause equipment malfunction or serious physical injury. This equipment mu

Line Starting and Line Stopping Connect a jumper between terminals 9 and 12. When AC line power is removed, the motor will coa

Regen Run-Brake Switch The Regen Run-Brake switch is optional. When the switch is in the open position, the motor will run. When the switch is close

OPERATION Before operating the control, carefully check that all connections are correct. Check that there are no wire chips or other foreign materia

IMPORTANT: A non-metallic screwdriver must be used when setting the trimpots to avoid any possibility of the screwdriver’s blade contacting live circu

15

Troubleshooting The printed circuit boards in these controls are built utilizing the surface mount technology and are not considered to be field repai

b) If line fuse does not blow but motor will not run: 1) Direction select speed adjust pot or unidirectional speed adjust pot may be defective. 2) Con

LIMITED WARRANTY - RG100UC/RG200UC For a period of one (1) year from date of original purchase Rapid-Air Corporation will repair or replace without c

19

Rapid-Air Corporation Operating Instructions Pallet Master - PMD 25, 35, 50 & 100 High Speed POWER The system is designed to operate on 120 VAC 5

20

21

Pre-Operation Check Before placing any material on the turntable ensure that all functions are in the correct mode for machine operation. i.e. 1. Swit

Operation 12. Place the coiled stock on the turntable. Center the material on the turntable within 1/2 inch from center. 13. Rotate the table slowly

Electronic loop height adjustment Eight different loop sensing arm operating positions are selected manually during set-up. In operation, the desired

Instruction for wiring Pallet Master Decoiler after shipping 1. See drawing (fig RA-1) 2. Feed wires from base through hole in control arm. 3. Bolt

7

The TAUT STOCK feature is built into the Rapid-Air board #69100035 and wired to external terminals 10-11-12. The terminal #12 is common and from term

Rapid-Air Corp. Minarik Adjustable Speed Control models RG100UC and RG200UC Specifications Input voltage RG100UC 115 vac, 50/60 hertz, single ph