Rapid-air CABINET REEL User Manual

RAPID-AIR CORPORATION4601 KISHWAUKEE ST. • ROCKFORD, IL 61109-2925Phone: (815) 397-2578 • Fax: (815) 398-3887 • Web Site: www.rapidair.comCABINET REE

5. Percent speed pot set too low. a. Adjust percent speed pot to 100%. 6. Fuses blown. a. Check fuses & circuit br

RAPID-AIR CORPORATION RAMM SOLID STATE DC MOTOR SPEED CONTROL SAFETY WARNING—PLEASE READ CAREFULLY This product should be installed and serviced by

PLUG IN HORSEPOWER RESISTOR A Plug-In Horsepower Resistor must be installed to match the RAMM to the motor horsepower and voltage. See table 2 for t

INTRODUCTION The RAMM Full Wave Solid State DC Motor Speed Control represents the latest state of the art design achievable through modern technology.

Fig. 1. Basic RAMM Connection Diagram B. VOLTAGE FOLLOWING. All models can be controlled with an isolated analog refer-ence voltag

1. AC Line Fuse is chosen according to the maximum rating of the control: 12 AMP fuse for all motors up to 3/4 HP-90V and 1 1/2 HP-180VDC

The following procedure, presented in order of adjustment sequence, should be used when read-justing all trimpot functions. Fig 2. ACCEL/DECEL TRIMP

To set the CL to factory specifications adjust as follows: 1. Set speed control knob at approximately 30-50% CW rotation. Set CL trimpot

LIMITED WARRANTY—RAMM 125, 225, 225D For a period of one (1) year from date of original pur-chase Rapid-Air Corporation will repair or replace withou

19

OPERATING INSTRUCTIONS CABINET REEL (Revision 1—2/94) INSTALLATION 1. The machine that you have just received is fully assembled and ready to be p

The main control unit is located behind the side access cover. Fig. Man 28 is an illustration of the layout of the control panel. This diagram lists

Mechanical Operating Procedure To Load or Unload a Coil Ring A) If your reel has a fixed center shaft go to Step - 1 B) If your reel has an adjustab

DANCER ARM LOOP HEIGHT ADJUSTMENT Three different loop sensing arm operating positions are selected manually during set-up. By selecting the higher n

START UP PROCEDURE Prior to applying power to the machine the operator should review all the controls on the ma-chine. A brief summary of the contro

9. LOOP ARM/EXTERNAL SWITCH This switch selects either dancer arm (internal) or “D” connector (external) speed control func-tions. 10. RESET BUTTONS

REEL SPECIFICATIONS AND MAINTAINCE CAPACITY SERIES 20 30

TROUBLE SHOOTING GUIDE MAIN SWITCH ON BUT NOT LIT 1. CB tripped a. Reset CB 2. Unit not plugged into main power. a. Plug i