Rapid-air STRAIGHTENER: SBX SERIES (ADJUSTABLE PLATEN STOCK User Manual

STRAIGHTENEROPERATING INSTRUCTIONSRAPID-AIR CORPORATION4601 KISHWAUKEE ST. • ROCKFORD, IL 61109-2925Phone: (815) 397-2578 • Fax: (815) 398-3887 • Web

DANCER ARM LOOP HEIGHT ADJUSTMENT Three different loop sensing arm operating positions are selected manu-ally during set-up. By selecting the higher

STANDARD STRAIGHTENER COMPONENTS CURVE UP/DOWN ADJUSTMENT Some applications have dies that cannot accept anything but flat stock and other dies run

OPERATION Once the straightener has been tested and all the functions work then it should be tested for what it was designed to do and that is to rem

MAINTENANCE LUBRICATION Gear transmission: The reservoir oil capacity is about 4 OZ. The reservoir oil should be changed every 2000 hours and shou

TROUBLESHOOTING GUIDE MAIN SWITCH ON BUT NOT LIT 1. CB tripped a. Reset CB 2. Unit not plugged into main power. a. Plug i

3. If running with external control a. Check that the external/loop arm switch is in the external position. 4. Height switch setting to

69100034 TAUT STOCK OUTPUT The 69100034—Proportional control board has a taut stock output. The output must be wired to a solid state relay as the m

17

RAPID-AIR CORPORATION RAMM SOLID STATE DC MOTOR SPEED CONTROL SAFETY WARNING—PLEASE READ CAREFULLY This product should be installed and serviced by

PLUG IN HORSEPOWER RESISTOR A Plug-In Horsepower Resistor must be installed to match the RAMM to the motor horsepower and voltage. See table 2 for t

INDEX 1. Straightener Layout Sheet Pg. 3 2. Platen Adjustment Bulletin Pg. 4 3. I

INTRODUCTION The RAMM Full Wave Solid State DC Motor Speed Control represents the latest state of the art design achievable through modern technology.

Fig. 1. Basic RAMM Connection Diagram B. VOLTAGE FOLLOWING. All models can be controlled with an isolated analog refer-ence voltage (0-6VDC) in

(Use Buss ABC, Littlefuse 326 ceramic fuse or equivalent.) 2. Armature Fuse can be chosen in accordance with the fuse chart. Note: The armature fu

The following procedure, presented in order of adjustment sequence, should be used when read-justing all trimpot functions. Fig 2. ACCEL/DECEL TRIMP

To set the CL to factory specification adjust as follows: 1. Set speed control knob at approximately 30-50% CW rotation. Set CL trimpot t

LIMITED WARRANTY—RAMM 125, 225, 225D For a period of one (1) year from date of original pur-chase Rapid-Air Corporation will repair or replace withou

26

27

28

29

3

30

31

32

33

4

SBX SERIES POWERED STRAIGHTNER INSTALLATION The straightener that you just received is fully assembled and tested and ready to be put into po-sition

MAIN CONSOLE AND CONTROLLER The main control console with controls is mounted on the cabinet of the straightener. Located on the face of the console

6. DANCER ARM LOOP HEIGHT AND RANGE ADJUSTMENT A. Loop Range—The loop range switch adjusts the amount of travel that the dancer arm will move to pro

8

9